How to get through the break-in period of new dry mortar equipment?

 Precautions for the use of complete sets of dry mortar equipment, usually refers to after the installation and commissioning of the equipment, customers need to pay attention to the use of matters, we start with the correct order of start-up, air compressor, mixer, tilting machine, packaging machine.
      When the mixer rotates normally, Tilting machine Tilting material slowly to join, the mixer motor load is slowly rising, will not bring damage to the equipment, start-up airstart is a key link in the maintenance of dry mortar equipment, is to make the bearings and other lubricating parts of the lubricated parts of the full lubrication of a step, the lack of which may lead to the bearing slippery tile, or bearing oil seal breakage.
      Just commissioned and installed a complete set of dry mortar equipment, because it is in the initial use of the break-in period, the general requirements of the equipment every day lubrication, each lubrication point needs to be both, the horizontal machine to tee up the side of the motor bearings, the floor-type machine to the mixer motor support seat bearings.
      And then according to the equipment capacity requirements of production, such as mixing volume of one side of the equipment, mortar can only mix a ton of mortar, lightweight materials mixing 0.6 square, such as putty powder, otherwise it will cause such as burning motor, bad bearings, broken mixing shafts and other equipment problems.
      Till machine feeding, first on the specific gravity of light raw materials such as cement, and then on the heavier than heavy raw materials such as sand, so that you can correct the complete set of dry mortar equipment life, in the production process, in order to correct the use of personnel's lives, then the control switch of the equipment have to be on its nuisance leakage treatment, strictly prohibit the non-brick industry personnel on the equipment for testing and maintenance, as well as debugging work.